Konica Minolta Network Setup - Manual (Page 20)

4 Changing the Device Setup
15
4.3 NetWare Print Setup
Note
Perform the following steps to configure a device for NetWare printing.
1.
On the device list, click the icon of the device you want to
configure.
2. Select Device Setup on the Setup menu to display the Device
Setup dialog box.
You could also click the toolbar button.
3. Click the NetWare Printing tab.
4. Perform the following steps.
• Set up the print server. See 4.3.1 Setting up the Print Server.
• Select the mode. See 4.3.2 Selecting the Mode.
• Set up the print queue. See 4.3.3 Selecting the Print Queue.
• Select users for event notification. See 4.3.4 Selecting Users for
Event Notification.
• Verify the setup. See 4.3.5 Verifying the Setup.
Note
• You must have NetWare Client 32 installed on your system in order to
setup for NetWare printing.
• NetWare supervisor privileges are required in order to change the
NetWare Print Setup. You must login to the NetWare network with
supervisor privileges in order to configure NetWare for printing.
• You must have IPX protocol installed on your device in order to
configure a NetWare print setup.
• If you have already configured a NetWare print setup with another tool,
the existing configuration will be deleted when you complete this setting.
• Clicking the NetWare Printing tab downloads the device
configuration. Downloading can take anywhere from a few seconds to
20 or 30 seconds or more. Wait for the download procedure to
complete before trying to do anything else.
• The community name input dialog box appears only if the SNMP
community name has been changed to something other than the default
name. Type in the community name and then click OK.