Konica Minolta Network Setup - Manual (Page 32)

5 Option Setup
27
5.3 Specifying BOOTP
Perform the following steps to specify the settings for operation as a
BOOTP server.
1.
Select Option on the Setup menu to display the Option dialog
box.
2. Click the BOOTP Setting tab.
3. To operate as a BOOTP server, put a check mark beside Enable
BOOTP Server , and then specify the following BOOTP server
settings.
To specify an IP address range for assigning the BOOTP server:
1.
Select the Using a range option.
2. Enter IP addresses into the Start and End boxes, and then click the
Append button.
The specified IP addresses are added to the Client List box.
To specify a single IP address for assigning the BOOTP server:
1.
Select the Individually option.
2. Enter an IP address into the Single box, and then click the
Append button.
The specified IP address is added to the Client List box.