Konica Minolta Network Setup - Manual (Page 22)

4 Changing the Device Setup
17
2. After you are finished configuring the setup, click the Next button.
Note
4.3.2 Selecting the Mode
Use the procedures in this section to select the server you want to
configure as the print server, or the NDS context.
If you are using bindery service (NetWare 3.x):
1.
Put a check mark into the NetWare 3.x Bindery Server check
box.
2. Click the button to display the Mode Select dialog box, which
shows a list of servers on the NetWare network.
3. Select the server you want to configure as the print server, and then
click the
OK button.
4. When everything is the way you want, click the Next button.
• To configure a NetWare print setup, the server must be bound to at least
one IPX frame.