KTM 990 - Manual (Page 87)

TROUBLE SHOOTING
»
TROUBLE CAUSE REMEDY
Flasher lights, brake light, horn
and multi-functional digital
speedometer fail
Bulb burned out
Blown fuse
Replace bulb
Replace fuse HORN BRAKELIGHT SPEEDO.
Time is not displayed or not cor-
rectly displayed
Blown fuse, thus no continuous
power supply
Replace fuse ACC 1 / CLOCK and set the clock.
The battery is discharged The ignition (power consumer) has-
n’t been switched off
The battery isn’t charged by the
generator
Recharge the battery according to the relevant instructions.
Voltage regulator and generator should be checked by an
authorized KTM workshop.
No values are visible in the
multi-functional digital
speedometer display.
Blown fuse Replace fuse HORN BRAKELIGHT SPEEDO.
The speed indication on the
multifunctional digital
speedometer is not working
Pickup cable is damaged or con-
tacts on the cable connector have
oxidized
Check the pickup cable for damage, visit an authorized KTM
workshop
The blink code (FI indicator lamp) indicates which component is affected by an error. This allows the error to be identified if no diagnosis
tool is available. The rhythm of the blinking lamp will let you determine the two-digit „blink code“,
e.g.: Blink code 34: FI blinks 3x long, 4x short, pause, Blink code 06: FI blinks 6x short, pause
86
BLINK CODE SIGNAL / COMPONENT ERROR DESCRIPTION ENGINE
02 Pulse generator Malfunction Stalls
06 Throttle sensor Output signal too low /high Continues to run
07 Sensor for 2nd throttle valve Output signal too low /high Continues to run
09 Intake manifold air pressure for sensor rear cylinder Output signal too low /high Continues to run
11 Intake manifold air pressure sensor for front cylinder Output signal too low /high Continues to run