KTM 990 - Manual (Page 95)

TECHNICAL SPECIFICATIONS – ENGINE
»
ENGINE 990 LC8
Design Liquid-cooled, 2-cylinder 4-stroke engine with 75° V arrangement with balancer shaft and electric starter
Displacement 999 cc
Bore / Stroke 101/62.4 mm
Compression ratio 11.5:1
Fuel unleaded fuel with at least RON 95 (USA: Premium PON 91*) / RON 80 - 94 for other ignition curve)
Valve timing 4 valves controlled over bucket tappet and 2 camshafts, camshaft drive with gears/chain
Valve diameter Intake: 38 mm Exhaust: 33 mm
Valve clearance, cold Intake: 0.10 - 0.15 mm Exhaust: 0.25 - 0.30 mm
Crankcase bearing Friction bearings (2 main bearings / 1 supporting bearing)
Conrod bearing Friction bearing
Piston pin bearing Dual-fuel bearing
Piston Light alloy – forged
Piston rings 1 compression ring, 1 taper face ring, 1 single-piece oil scraper ring with spiral-type expander
Engine lubrication Dry sump with 2 trochoidal pumps (pressure pump and suction pump)
Engine oil SAE 10W-50 ( Motorex Power Synt 4T) #
Quantity of engine oil approx. 3.0 liters during oil/filter change
Primary drive Straight-toothed spur wheels 35 : 67
Clutch Multi-disc clutch in oil bath
Transmission 6-speed claw shifted
Gear ratio
1st gear 12:35
2nd gear 15:32
3rd gear 18:30
4th gear 20:27
5th gear 24:27
6th gear 26:27
94