Kodak 6J7611A - Manual (Page 26)

3-10 A-61500 May 2010
Continuous feeding Continuous feeding can be used when you want to scan small batches
of documents (less than 25).
When the scanner is configured for continuous feeding, the elevator
tray is raised to a position where approximately 25 documents can be
loaded. The elevator tray will remain in this position to allow more
documents to be loaded to the bottom of the stack.
To continuously feed documents, follow Steps 1 through 5 above. As
the documents are being scanned, you can continuously add a batch of
documents to the bottom of the stack.
NOTE: Depending on how your scanner is configured, the transport will
stop when the Transport Timeout has been reached.
Manual feeding
To manually feed documents:
1. Position the document you want to feed in the elevator tray so that
the paper present sensor is covered.
2. Press Start/Resume.