Konica Minolta DYNAX 3 - Manual (Page 12)

23 22
LENS
Remove the body and rear
lens caps.
Align the red mounting index
on the lens and camera
body. Carefully insert the
lens into the mount, then
turn it clockwise until it
clicks into the locked
position.
• Do not insert the lens at an angle.
While pressing the lens release,
turn the lens counter-clockwise
until it stops. Carefully remove
the lens.
• Replace the caps on the lens and
attach the body cap or another lens
on the camera.
This camera uses interchangeable lenses. See page 114 for information
on which lenses are compatible with this camera.
Attaching the Lens
Removing the Lens
FILM
Press the back-cover
release to open the back
cover.
Always load or remove the film under subdued light to reduce the
chances of fogging.
• Never force the lens. If it does not fit, check its orientation with the index
marks. When removing, make sure the lens release is pressed all the way
down.
• Do not touch the inside of the camera, especially the lens contacts and
mirror.
Loading the Film
1
2
1
Insert the film cartridge
into the film chamber. 2
• Do not use Polaroid Instant 35mm film. Winding problems may occur.
• Do not use infrared film in this camera. The camera’s frame counter
sensor will fog infrared film.
• If non-DX-coded film is used, the camera will use the previous roll’s ISO
setting. Refer to page 84 to set the film speed manually.
• More than 40 exposures can not be taken on one roll with this camera.
When using 72-exposure film, the camera will start to rewind the film after
40 exposures have been made.
The camera automatically sets the correct film
speed (ISO) with DX-code film.
Continued on next page
GETTING ST
ARTED