Konica Minolta DYNAX 3 - Manual (Page 54)

CUST
OM
FUNCTIONS
107
(1) Shutter-release Lock Off
Shutter can be released even if there is no film in the camera.
(2) Shutter-release Lock On
Shutter cannot be released unless film is loaded.
• When film is not loaded, if the shutter-release button is pressed all the way
down, 0 will blink in the viewfinder and on the data panel.
• While the back cover is open, the shutter can be released.
Custom 5 - Shutter-release Lock (Film)
(1) DX Memory Off
Film speed is always set to the DX-coded ISO of the film. Non-DX-coded
film is set to the ISO of the previous DX-coded roll.
(2) DX Memory On
Manual changes to the film speed of a DX-coded film are saved and
applied to future rolls with the same DX-coded ISO. Use when a
particular film is consistently pushed or pulled in its processing.
• For setting the film speed manually, see page 84.
Custom 4 - DX Memory
(1) Film Tip Rewound
Film is completely rewound into the cartridge.
(2) Film Tip Left Out
The film leader is exposed after rewind.
• Sliding the main switch to OFF during rewinding causes the film tip to be
rewound into the cartridge when the camera is turned on again.
Custom 3 - Film Tip
106
(1) Automatic
Film is automatically rewound at the end of the roll.
(2) Manual
The manual-rewind button must be pressed to initiate rewind (p. 26).
Custom 2 - Film Rewind Start
(1) AF priority
Shutter will not release until
or appears in the viewfinder.
(2) Shutter-release Priority
Shutter releases even if the focus cannot be confirmed. Use shutter-
release priority when photographing moving subjects.
• When continuous-advance mode is selected, the camera will not update
the focus while the shutter-release button is pressed.
Custom 1 - AF / Shutter-release Priority
You can reset all of the custom functions to their default settings (1).
Turn the main switch to OFF.
Turn the function dial to CUST.
While pressing the function button, slide the main
switch from OFF to ON.
• When the camera turns on, will blink
on the data panel while the function button
is pressed.
Resetting All of the Custom Functions to Default
1
3
2
CUSTOM FUNCTIONS