Kobe Range Hoods CX1830GS-8 - Manual (Page 10)

8
Wiring to Power Supply
S A F E T Y W A R N I N G
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
9. Connect three wires (black, white and green) to house wires.
10. Connect according to color: black to black, white to white, and green to green and cap with
wire connectors.
11. Test the operation of the hood before moving on to the next step. Make sure power is supplied
to the hood.
12. If venting outside, skip to Step 19, Ductwork Installation.
Recirculating Conversion
Requires Purchase of Recirculating Kit Model No. RD-0183.
13. For the recirculating installation, replace the duct cover-mounting
bracket with the T-Box. Using references in Table 1 and
Measurement & Diagrams on page 15 to mark the leveling line for
the T-Box. Secure the T-Box with 3 screws (not provided) to the
wall. Use duct tape to seal joints from plastic damper to T-Box.
(Recirculating Duct Cover will hook onto T-Box.)
Refer to Figure 13.
14. Measure the distance from the top of the plastic damper to the ceiling and prepare a 7” round
metal duct pipe with 4” shorter than measured distance.
15. Use the prepared 7” round metal duct pipe to connect the T-Box to the plastic damper. Use
duct tape to make all joints secure and air tight. Make sure pipe is in the groove of the plastic
damper. Refer to Figure 14
16. Remove stainless steel filters and install the carbon filters. (Refer to Figure 20)
17. Re-attach the stainless steel filters.
18. Skip to Step 21, Duct Cover Installation
Figure 13