Kobe Range Hoods CX1830GS-8 - Manual (Page 11)

9
Ductwork Installation
19. Use 7” round aluminum or steel pipe to connect the plastic
damper on the hood to the ductwork above.
20. Use duct tape to make all joints secure and air tight. Make sure
pipe is in the groove of the plastic damper. Refer to Figure 14
Duct Cover Installation
21. (SKIP STEP 22 and 23 IF USING THE RECIRCULATING CONVERSION KIT. YOU WILL
NOT NEED THE DUCT COVER-MOUNTING BRACKET.) Using references in Table 1 and
measurements on page 17, mark the leveling point for duct cover-mounting bracket.
22. Secure the duct cover-mounting bracket to the wall with two screws (not provided). Refer to
Figure 15. Make sure all screws are tightened.
23. Hook the inner duct cover onto the duct cover-mounting bracket and release the outer duct
cover to fit onto the hood as shown in Figure 15 and 16.
Final Assembly
24. Rotate the oil container clockwise to install it.
Shown in Figure 17.
25. Turn power ON in control panel. Check all lights and fan operation.
26. Make sure to leave this manual for the homeowner.
Figure 14
Figure 15 Figure 16
Figure 17