Kenwood KDC BT948HD - Manual (Page 68)

P.CONT
ILLUMI
ANT.
CONT
MUTE
REMOTE
CONT
STEERING
WHEEL
REMOTE
INPUT
– +
L R
L R
FM/AM antenna input
Front output
Fuse (10A)
Microphone
(Accessory5)
Microphone input
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Blue/White (Power control wire)
Blue (Antenna control wire)
Orange / White (Dimmer control wire)
When using the optional power amplifier, connect to its power control
terminal.
To car light control switch
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
Sub Woofer output
Brown (Mute control wire)
Rear output
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
Light Blue/Yellow (Steering remote control)
To Kenwood disc changer/ External optional accessory
⁄ To connect these leads, refer to the relevant
instruction manuals.
To connect the Kenwood navigation system, consult your navigation
manual.
USB connector
(0.8 m (2.7 ft))
To USB device
⁄ Do not remove the cap
when you do not use the
USB cable. The connector
will cause the unit to
malfunction if it gets in
touch with any metallic
part of the vehicle.
Wiring harness
(Accessory1)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
(3.5 mm (1/8”) ø)
Antenna Cord
68
| KDC-X995/ KDC-BT948HD
Connecting Wires to Terminals