Kohler Command CV730 User Manual

Page 114

Advertising
background image

7.2

Section 7
Retractable Starter

6. Tie a single knot in one end of the new rope.

7. Rotate the pulley counterclockwise (when

viewed from pawl side of pulley) until the spring
is tight (approximately 6 full turns of pulley).

8. Rotate the pulley clockwise until the rope hole in

the pulley is aligned with the rope guide bushing
of the starter housing.

NOTE: Do not allow the pulley/spring to

unwind. Enlist the aid of a helper if
necessary, or use a C-clamp to hold the
pulley in position.

9. Insert the new rope through the rope hole in the

starter pulley and the rope guide bushing of the
housing. See Figure 7-3.

Keep Pulley
from Rotating

Rope Guide
Bushing

Rope Hole
in Pulley

Figure 7-3. Installing Rope.

10. Tie a slipknot approximately 12 in. from the free

end of the rope. Hold the pulley firmly and allow
it to rotate slowly until the slipknot reaches the
guide bushing of the housing.

11. Slip the handle and rope retainer onto the rope.

Tie a single knot at the end of the rope. Install the
rope retainer into the starter handle.

12. Untie the slipknot and pull on the handle until

the rope is fully extended. Slowly retract the rope
into the starter. When the spring is properly
tensioned, the rope will retract fully and the
handle will stop against the starter housing.

Pawls (Dogs) Replacement

To replace the pawls, follow disassembly steps 1-4
and reassembly steps 3-8 on the following pages. A
pawl repair kit is available which includes the
following components:

Description

Qty.

Pawl Retainer
Center Screw
Pawl (Dog) Spring
Brake Spring
Starter Pawl (Dog)
Brake Washer
Washer

1
1
2
1
2
1
1

Disassembly

WARNING: Spring Under Tension!

Do not remove the center screw from starter until the spring
tension is released. Removing the center screw before releasing
spring tension, or improper starter disassembly, can cause the
sudden and potentially dangerous release of the spring. Follow
these instructions carefully to ensure personal safety and
proper starter disassembly. Make sure adequate face protection
is worn by all persons in the area.

1. Release spring tension and remove the handle

and starter rope. (Refer to “Rope Replacement,”
steps 2 through 5 on page 7.1).

2. Remove the center screw, washer, and pawl

retainer. See Figure 7-4.

3. Remove the brake spring and brake washer. See

Figure 7-5.

4. Carefully note the positions of the pawls and

pawl springs before removing them.

Remove the pawls and pawl springs from the
starter pulley.

Advertising
This manual is related to the following products: