Kohler Command CV730 - Manual (Page 66)

5.32
Section 5
Fuel System and Governor
Choke Lever Detail
Figure 5-68. Governor Used with Commercial Mower Air Cleaner (CV17-745).
Commercial Mower Governor
Arrangement
The Commercial Mower governor arrangement shown
in Figure 5-68 is used primarily on wide area walk
behind mower applications. The initial adjustment
and sensitivity adjustment is the same as for the
standard governor. The governor and controls for the
CV750 engine is shown in Figure 5-69. Should the
governor spring be disconnected from the throttle
lever and governor lever, reconnect it as follows:
1. Hook the long end of the spring through the hole
in the lever from the left side.
2. Rotate the spring 180° until hooked as shown in
Figure 5-69.
3. Hook the short end of the spring into the
appropriate hole in the governor lever. Refer to
the appropriate chart in Section 11 - "Reassembly"
of this manual for the correct hole to use for the
speed involved.
Choke Cable Choke Lever
(See Detail at Left)
Clamp
Throttle
Cable
Spring
Bushing
Linkage
Throttle Lever
Washer
Throttle Shaft
Bracket
Spacer
Deflector
(If So Equipped)
(Place Between Valley
Baffle and Throttle
Shaft Bracket)
Bushing
Blower Housing
Washer
Lever
Spring
Screw and Nut
Control Lever
Control
Bracket
Spring
Clip
Locker Nut
Fuel Line
Clamp
Fuel
Pump
Fastener
Lock Nut
Fastener
Choke Lever
Spacer
Spring
Washer
Bushing
Screw
Lock
Nut
Washer
Linkage