Kohler SIPHON VORTEX LOW PROFILE ONE-PIECE TOILETS K-3402-EB - Manual (Page 9)

- 9 -
LUSTRA SEAT REMOVAL
1. Refer to Fig. #24. Pry up seat hinge post covers and
loosen screws. Remove wing nuts.
Lustra Seat Removal
Fig. #24
Seat Hinge Post
Covers
Screw
Wing Nut
2. Remove seat from toilet.
PILLOW TALK SEAT REPLACEMENT
1. Refer to Fig. #25. To install Pillow Talk toilet seat, slide
hex head bolts through holes in the two hinge blocks.
Slide bushings onto bolts.
2. Notice that the bushing and hinge block are serrated.
This allows you to adjust the toilet seat to the correct
position before tightening. Place toilet seat onto toilet
by inserting the hinge block/bushing assemblies
through the two holes on the toilet. Once the bushings
are inserted into the holes the toilet seat can be adĆ
justed. Adjust hinge block/bushing forward or backĆ
ward until seat position is correct. Make sure the seat is
placed squarely on the toilet.
3. Thread wing nuts onto hex head bolts from underside
of toilet. An indentation on the hinge block will prevent
the hex head bolt from turning when the wing nut is
tightened.
4. Attach bolt covers as shown.
Pillow Talk Seat Replacement
Fig. #25
ЛЛЛ
ЛЛЛ
ЛЛЛЛ
ЛЛЛЛ
ЙЙЙ
ЙЙЙ
ЙЙЙ
ЙЙЙ
ЙЙЙ
ЙЙ
ЙЙ
ЗЗ
ЗЗ
ЗЗ
ЗЗ
ЗЗ
ЗЗ
GENERAL TOILET TROUBLESHOOTING (ALL
MODELS)
If toilet won't shut off or is leaking, perform the following
procedure for initial troubleshooting, then refer to the apĆ
propriate chart on the following pages.
1. Shut off water supply. Note the water line inside the
tank.
2. Wait at least an hour and recheck the water level.
3. If the water level is at the top of the toilet's overflow tube
or has not dropped, the water level may be too high, or