Kenwood VZ-7000P - Manual (Page 10)

English
10
System Setup Function
FM Transmitter Function On and Off
If the Center unit is not connected, you can use the
FM transmitter function to hear the audio from the
TV, video played from your car FM radio.
Touch [ ON ] or [ OFF ] to switch the FM transmitter
function on and off.
[ 7ON] : FM transmitter function is turned on
[ 7OFF] : FM transmitter function is turned off
The sound from FM transmitter is monaural.
Adjusting the FM Transmitter Frequency
When the FM transmitter function is turned on, you can
switch the transmission frequency as follows:
Touch [ 3 ] to increase the frequency by one step.
Touch [ 2 ] to decrease the frequency by one step.
• Be sure to select a frequency that is not the same
as a broadcast station in your area.
• The “Auto Seek” function on your car radio may not
stop at the FM transmitter frequency. In this case,
use the “Manual Seek” function to set the radio to
the FM transmitter frequency.
• If the hideaway unit is grounded the audio signal
from the FM transmitter may be difficult to hear.
Ending the FM Transmitter Setting Screen
Touch [ RTN ] to return to the setup menu screen.
NOTE
NOTE
RTN F M - X T
O N O F F
F M - T X
F M - T X
9 , 8 9 M Hz
FM Transmitter Setting Screen
Setting the TV Area
Select the area for TV broadcast viewing.
Selecting the Preset Bands:
Touch the [TV 1] or [TV 2] button.
Selecting the Reception Area:
Touch the [ 71] - [75] button.
Select the channel setting for your country as follows.
The reception area can be set for two separate preset
bands TV1 and TV2.
Ending the TV Area Setting Screen
Touch [ RTN ] to return to the setup menu screen.
NOTE
T V 1 T V 2
1 2 3 4 5
RTN T V A R E S A E T
I n d o n e s i
a n d l
a •
a e Z w e N •
TV Area Setting Screen (VZ-7000P only)
China
Singapore
Malaysia
Thailand
Burnei
Hong Kong
Indonesia
New Zealand
Australia
[ 71]
[ 72]
[ 73]
[ 74]
[ 75]
PAL-D
PAL-B/G
PAL-I
PAL-B/G
C-01177(H)-Eng 02.3.20 3:12 PM Page 10