Kenwood VZ-7000P - Manual (Page 15)

Name Set
If the cursor is in the desired character input
position, go on to step 4. If not, touch either [
2 ] or
[ 3 ] to move the cursor to the desired position.
Touching [ 2 ] moves the cursor to the left and
touching [ 3 ] moves it to the right.
Touch [ ∞ ] or [ 5 ] to switch the character lists.
When all characters are displayed on the character
list, [
∞ ] and [ 5 ] do not appear.
Touch [ A B ], [ a b ], [ 1 2 ] or [ Д д ] to switch the
character lists.
Touch a character.
Continue steps 1 and 4 until all the characters have
been input for the name.
• You can enter up to 12 characters for each name.
• To enter a space, touch [ SPC ].
Touch [ OK ] to finish name entry and leave the
name preset mode.
• If you want to change the name of a station, first
display the name of the station (following step 1),
then change the letter(s) that you by following steps
1, and 4.
• You can assign names to up to 30 TV stations.
• Names registered on this unit will not be displayed
on the Center unit.
NOTE
6
NOTE
5
4
3
NOTE
2
1
English
15
A
N A M E # P R E S E T #
B C D E F
G H I J K L
M N O P Q R
S T U V W X
Y Z , . • -
O K N A M E S E T
S P C
A B
a b
1 2
Д д
Name Set Screen
C-01177(H)-Eng 02.3.20 3:12 PM Page 15