Kenwood VZ-7000P - Manual (Page 11)

English
11
Setting of the switching mode of input
video signal types
This function switches between the automatic
detection and the fixed detection for input signal
types of VIDEO1 and VIDEO2.
VD1 MODE
[ 7AUTO] : Setting of the automatic detection mode
[ 7NTSC] : Setting of the NTSC fixed mode
[ 7PAL] : Setting of the PAL fixed mode
VD2 MODE
[ 7AUTO] : Setting of the automatic detection mode
[ 7NTSC] : Setting of the NTSC fixed mode
[ 7PAL] : Setting of the PAL fixed mode
It may take time to enable the automatic detection
when “AUTO” is set.
Ending the Video Setting Screen
Touch [ RTN ] to return to the setup menu screen.
NOTE
RTN V I D O E
P A L A U T O N T S C
P A L A U T O N T S C
V D 1 M O D E
V D 2 M O D E
Video Setting Screen (VZ-7000P only)
Adjusting the Time [CLOCK]
If the Center unit is not connected, you can set the
clock time.
Setting the Minutes to "00":
Touch [ RESET ] to set the minutes to "00".
Touch [ RESET ] while the minute is below "30"
rounds it off, and while the minute is "30" or more
rounds it up.
Ending the Clock Adjustment Screen
Touch [ RTN ] to return to the setup menu screen.
NOTE
1 2 : 0 0 P M
RTN
R E S E T
C L O K C A D J U S T
C L O C K
Clock Adjustment Screen
1 2 : 0 0
C L O C K
Touch [ ∞ ] to make the
hours go back.
Touch [ ∞ ] to make the
minutes go back .
Touch [ 5 ] to advance
the hours.
Touch [ 5 ] to advance
the minutes.
C-01177(H)-Eng 02.3.20 3:12 PM Page 11