Kohler Power Systems 14/20RESA - Manual (Page 44)

TP-6804 12/11 44 Section 3 RDC2 Controller Operation
3.18.1 Networking Status Submenu
The Networking Status submenu contains settings for
OnCue
t. See the OnCue Software Operation Manual
for information about the appropriate network settings
for OnCue. Changes to these settings are not typically
required.
If DHCP is enabled, IP parameters are not displayed. If
DHCP is disabled (i.e., if a static IP address is used), the
IP parameters are displayed.
To enable or disable DHCP and change the IP settings,
go to the Networking Configuration menu.
See
Section 3.18.2.
tp6804
IP Address:
123.456.789.123
Gateway:
123.456.789.123
<---- Return
Subnet Mask:
123.456.789.123
DHCP:
Enabled
Ethernet Status:
Disconnected
DNS 1:
123.456.789.123
DNS 2:
123.456.789.123
OnCue Server:
123.456.789.123
OnCue Status:
Connected Networking---->
Status
Networking---->
Information
Figure 3-20 Network Status Submenu