Kathrein MobiSet 2 Digital CAP 600 - Manual (Page 22)

22
INSTALLATION AND CONNECTION
Under certain circumstances, problems can arise when the units are connected to different connecting
sockets or circuits/earth potentials. If none are available, it is recommended that you connect the connecting
sockets for receiver and TV set to the same cable, as depicted in Figure “G”. The current rating of the circuit
used must be checked with respect to the intended application.
Further information on operating the UFS 740sw receiver can be found in the operating manual supplied
with the unit.
Only for connection in a motor home, not in a caravan!
• The third, green connecting cable, marked “IGNITION” allows you the option of connection to a circuit in
the vehicle that is activated when the ignition key is turned and then carries a continuous 12 V supply.
This type of connection ensures that when the engine is started the antenna is automatically lowered
into the park position (the receiver does not need to be turned on).
• Check the connections before you re-connect the on-board network.
• For commissioning and more detailed information on additional operator functions, we refer you to the
separate operating manual enclosed.
FUNCTIONAL INSTRUCTIONS FOR CONNECTION TO THE ON-BOARD POWER SUPPLY