Kathrein MobiSet 2 Digital CAP 600 - Manual (Page 53)

53
SPECIAL MESSAGES FROM THE TURNTABLE
The following messages are shown on the screen to protect your reception system and the on-board power
supply:
SYSTEM PROTECTION MESSAGES
The power supply to the turntable is insuffi cient (battery voltage below minimum value). The turntable
can still be moved, but communication errors can occur between the UFS 740sw and the turntable
(e.g. when scanning for satellites).
If the voltage falls still further, both the following error messages are displayed:
Check the power supply to the turntable and whether
it is obstructed (e.g. by a branch). If both causes of
faults are displayed, the turntable motor temperature
is in the critical range. Allow the turntable to stand
for a few minutes in its current position, until the
turntable motor temperature has reduced. You can
also however move the turntable to the park position
and let it cool down there.
Press the button and the turntable will move to
the park position.
Press the button to confi rm the displayed
message. The turntable cannot be moved any
more. Check the power supply to the turntable.
Note: The antenna should not be moved whilst the battery is being recharged, to prevent peak
loads when turning on.