Next – Kyocera FS-C1020MFP User Manual
Page 228
Top Page
>
>
Scanning Using the Control Panel
size according to the size of the original
Specifying the scanning size according to the size of the original
This section describes how to specify the scanning size according to the size of the current original.
Press the [Reduce/Enlarge] key.
Press the [Reduce/Enlarge] key or [ ][ ] keys to select the size of the original, and
then press the [OK] key.
If you selected anything other than [Custom], you do not need to perform the remaining steps of the
procedure.
Press the [ ][ ] keys to select [mm] or [Inch], and then press the [OK] key.
Enter the horizontal value using the number keys, and then press the [OK] key.
You can press the [ ][ ] keys to change the value in 1 mm or 0.1 inch increments.
Confirm the setting, and then press the [OK] key.
Enter the vertical value using the number keys, and then press the [OK] key.
You can press the [ ][ ] keys to change the value in 1 mm or 0.1 inch increments.
●
Use the following keys to cancel settings:
❍
[ ]: Cancels the changes made to settings and returns the display to the previous screen.
❍
[Clear/Stop]: Cancels the changes made to settings and returns the display to the initial screen.
●
You can change the machine's default [Document Size] setting to always scan originals with a specific scanning size.
●
Temporary job settings are cleared in the following cases:
❍
When no input is received for the period of time specified in [Auto Clear] while the initial screen is displayed.
❍
When the [Clear/Stop] key is pressed while the initial screen is displayed.
❍
When the machine's mode is changed.
❍
When the power is turned off.
❍
When the machine's default for the same setting is changed.
Contents