Kyocera FS-C1020MFP - Manual (Page 347)

Sets the machine to connect to the public switched telephone network (PSTN) or a private branch
exchange (PBX).
Default: [PSTN]
●
PSTN
●
PBX
PBX Access Digit
Specifies the dial number to access the outside line when the machine is connected to a PBX.
Make sure that this setting matches the setting of your PBX. Otherwise, you may not be able to send
faxes to outside destinations.
Default: 9
●
000 to 999, in increments of 1
Default Mode
Specifies the mode that is activated when the power is turned on, or if the time specified for [Auto
Clear] elapses without activity while the initial screen of the current mode is displayed.
Default: [Copy]
●
Copy
●
Fax
Auto Clear
Sets the machine to return to the initial screen of the current mode if the machine receives no input
for a specified period of time during configuration.
Also, if the specified period elapses while the initial screen of the current mode is displayed, the
machine returns to the mode specified in [Default Mode].
Default: [On] (30 seconds)
●
On (30 sec, 1 min, 2 min, 3 min, 5 min, 10 min)
●
Off
Power Saver
Sets the machine to enter Energy Saver mode, Energy Saver mode 1 or Energy Saver mode 2, to
reduce power consumption. The machine recovers from Energy Saver mode when it receives a print
job, prints a received fax, or when the [Copy], [Color Start], or [B&W Start] key is pressed.
●
EnergySaverMode1
The machine enters Energy Saver mode 1 if the machine has been idle for about 30 seconds.
It takes less time to recover from Energy Saver mode 1 than from power-off state or Energy
Saver mode 2, but power consumption is higher in Energy Saver mode 1 than in Energy Saver
mode 2.
Default: [On]
❍
Off
❍
On (30 seconds)
●
EnergySaverMode2
The machine enters Energy Saver mode 2 after the period of time specified for this setting is
passed. The machine consumes less power in Energy Saver mode 2 than in Energy Saver
mode 1, but it takes longer to recover from Energy Saver mode 2 than from Energy Saver
mode 1.
Default: [On] (2 minutes)
❍
On (1 to 240 minutes, in 1 minute increments)
❍
Off
Display Language
Specifies the language used on the screen and in reports.
Default: [English]