Kenwood HM-DV6MD - Manual (Page 42)

42
Recording on MD
Basic section
When you press the set key while "TRACK MARK" is displayed, a menu for selecting whether the track num-
bers are to be marked automatically during recording (AUTO) or marked manually by yourself during or after
recording (MANUAL). Select either option with the volume/multi-control knob and press the set key.
The initial setting is "AUTO". The track numbers are used when playing back the recording, searching for a
track or programming tracks.
Track number marking in MD recording ( TRACK MARK)
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "TRACK MARK", then press the
SET/DEMO key.
3
Turn the VOLUME/MULTI CONTROL knob
to select "AUTO" or "MANUAL", then press
the SET/DEMO key.
AUTO :
Usually, use this position for recording.
When recording audio from a DVD (MP3 or VCD) or recording analog audio from a CD, the MD track num-
ber increments as the CD track changes. When an external input is recorded, the MD track also increments
by "1" at the moment the input signal which has been below a certain level for more than 2 seconds in-
creases above the level. (When tuner reception is recorded, the track number may sometimes fail to incre-
ment due to signal noise, etc.). When recording music containing a continuous section with a very low
level, for example when recording classic music, the track number may be incremented by "1" after such a
section. In this case, cancel the track number later. It is recommended to use the MANUAL mode when
recording such a kind of music. (by executing the COMBINE operation h).
During digital recording of CD, the track number is incremented automatically by “1” according to the
data contained in the digital information. The no-sound blank is not detected.
When the CD track number is increased during manual search of a CD, the track number recorded on
the MD may sometimes fail to be incremented.
A no sound track may sometimes created at the moment the played disc stops.
MANUAL:
With this setting, the MD track number is not incremented automatically during re-
cording. Track numbers can be marked either during editing (by pressing the TRACK
EDIT key) or after recording (by executing the DIVIDE operation f).
This setting is convenient when recording a CD which has been recorded in live or
which contains very low-level sound such as a classical music CD.
TRACK EDIT
TRACK MARK indicator
R A T C K M A R K
A U T O
LP 2 A.TNO DIGITAL