Kenwood TK-2180 - Manual (Page 24)

18
To enter the password without using the DTMF keypad:
1 Rotate the selector to select a digit.
2 Press the C> key to accept the entered digit and move
to the next digit.
• Press the A key to delete an incorrect character. Press
and hold the A key to delete all entered characters.
3 Press the S key to confirm the password.
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.
A
DJUSTING THE
V
OLUME
Rotate the Power switch/ Volume control to adjust the
volume. Clockwise increases the volume and counter-
clockwise decreases it.
S
ELECTING A
Z
ONE AND
C
HANNEL
/ G
ROUP
ID
Select the desired zone using the selector or the keys
programmed as Zone Up/ Zone Down.
• The default setting for the selector is Zone Up/ Down.
Select the desired channel or group ID using the selector or
the keys programmed as CH/GID Up/ CH/GID Down.
• The default setting for the <B key is CH/GID Down.
• The default setting for the C> key is CH/GID Up.
Names can be programmed for zones and channels/ group
with up to 12 characters each. However, to fit on the display,
names will be abbreviated. Your dealer can set the zone
name to a length of 0 to 12 digits. Channel/ group ID names
will shorten appropriately, to fit in the 12-digit display.
For example, if the channel/ group ID name is “–CHANNEL1–”
and the zone name is “KENWOOD”, and your dealer sets the
zone name to 3-digits, the following display will appear: