Kenwood TK-2180 - Manual (Page 31)

25
SCAN
If the Scan function is programmed, zones or channels can be
scanned by pressing the key programmed as Scan. Scan
can be used as either Single Scan, Multi Scan, or List Scan.
• Single Scan monitors only the channels of the currently selected
zone, which have been added to the scanning sequence. If set
up to scan Priority channels, the Priority channels will be scanned
even if they are not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been
added to the scanning sequence.
• List Scan monitors all channels within the specified range of
zones, which have been added to the scanning sequence. If set
up to scan Priority channels, the Priority channels will be scanned
even if they are not within any of the zones in the list.
To activate Scan, press the key programmed as Scan.
• The icon and “ ” or the revert zone and channel/ group ID
number appear on the display.
• The zone add indicator ( ) will appear on the
display when the selected zone is added to the scan sequence.
The channel/ group ID add indicator (
) will appear
on the display when the selected channel/ group ID is added to
the scan sequence.
• When a call is received, scanning stops and the zone and
channel/ group ID digits appear. Press the PTT switch and speak
into the microphone to respond to the call. The transceiver will
continue scanning after a predetermined time delay if the PTT
switch is released and no further signal is received.
To stop scanning, press the Scan key again.