Kodak 1500 - Manual (Page 26)

18 Chapter 3 Getting Started
Inserting the Cable into a Wired Camera
To insert the cable into a wired camera, hold the camera in one
hand and insert the cable end into the bottom of the camera.
Make sure the cable is locked into place.
Figure 10 Inserting the Cable
To release the cable, press the Cable Release button and gently
pull the cable out.
Installing the Camera Holder
To install the camera holder, follow these steps:
1 Choose a clean area on the wall that you can easily access.
2 Clean the surface on which you are going to fasten the
camera holder.
3 Remove the adhesive tape protection from the support (2).
4 Place the taped side of the camera holder on the clean
surface and press firmly several times for correct
adherence. The maximum adherence is obtained after two
hours. So, you must avoid all stress on the camera holder
during the first two hours.
Cable Release
button