Pairing one camera to several docking stations – Kodak 1500 User Manual
Page 36
28 Chapter 3 Getting Started
Pairing One Camera to Several Docking Stations
To pair one camera to two or more docking stations, follow
these steps:
1
Plug in the DC power cord and connect it to the docking
station
2
Connect the USB cable from the rear of the docking station
to an open computer USB port.
3
Connect the camera USB cable from the front of the
docking station to the camera.
4
Power ON the camera.
5
Open KODAK dental imaging software and the acquisition
module in order to see live video on the computer.
6
Perform the pairing by continuously pressing down on both
the camera Power On button and the Shutter Release
button for at least five seconds until the following message
appears on the computer monitor: "Docking station and
Camera have paired successfully".
7
To pair the camera to additional docking stations, repeat
steps 1 to 6.
8
After pairing all docking stations, replace the USB cable on
the camera with a charged battery.
9
Restart the camera and operate it in wireless mode.
Note: To pair one camera to several docking
stations, you must connect each docking
station to one specific computer.