LG B-VENT GAS GC3 User Manual

Page 9

Advertising
background image

9

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

z

ero

C

learanCe

f

ireplaCe

i

nstallation

This insert may be installed in a masonry or factory built/zero

clearance (ZC) fireplace. When installing in a ZC fireplace,

the ZC grate must be removed and the ZC damper must be

removed or secured open. The ZC doors, screen, refractory

or masonry lining, baffles, and smoke shelf may be removed,

if necessary, to install the gas insert. However, do not cut

or alter the fireplace components. The removal of any parts

to facilitate installation must not alter the integrity of the

inner or outer shells of the fireplace cabinet. See Fireplace

Requirments on page 4.

g

lass

d

oor

r

emoval

See page 17 for Glass Door Removal Instructions.

b

riCk

l

iner

i

nstallation

HANDLE THE BRICK PANELS WITH CARE (SEE FIGURE 8)

AS THEY ARE FRAGILE. DO NOT FORCE THE PANELS INTO
THE FIREBOX AS THEY WILL BREAK IF FORCED.

1. Open and remove glass door, see “Front Door Remov-

al”

2. The longest panel goes in the rear of the firebox. Tilt the

top of the panel forward, insert the bottom of the panel

in the brick panel retainer and push the panel to the up-

right position.

3. Install the side panels by sliding the top of the panel into

the top side brick retainer and then dropping the bottom

of the panel into the bottom retainer. The rounded edge

on the side brick panels goes toward the front.

3

-Piece Brick Panel Set

l

og

i

nstallation

i

nstruCtions

CAUTION: If the logs are not properly installed, your insert

will not function properly.

Part list: Rear log, Right Front log, Left Front log, and

Top Twig

1. Remove the logs from the box and carefully unwrap them.

The logs are fragile, so handle them with care.

2. Place the rear log with the charred surface forward, on

the two rear locating pins (see Figure 9).

3. Place the left front log, with the charred surface forward,

(see Figure 10) on the two left front locating pins. Next

place the right front log, with the charred surface forward,
on the two right front locating pins.

Continued on Page 10...

Right Front Leg

Figure 2

Left Front Leg

Figure 1

Rear Log

Right Front Leg

Figure 2

Left Front Leg

Figure 1

Rear Log

Rear Log

Left Front

Log

Right Front

Log

Figure 8

Figure 10

Figure 9

Advertising