LevelOne ViewCon KVM-0850 - Manual (Page 14)

KVM-0850/1650 IP KVM switch
Step 9
Connect the Ethernet and/or modem, ISDN, depending how you want to access KVM-0850/1650.
INTERNET
MODEM
The rear side of KVM-0850/1650 provides a RJ-45 connector for Ethernet. The connector is used
either for a 100 Mbps 100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The adapter
can sense the connection speed and will adjust to the appropriate operation mode automatically.
10 Mbps Connection
For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4, or 5 UTP
cable. To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T
hub.
¾
Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
¾ Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, KVM-0850/1650 supports Category 5 UTP
cabling. To establish a 100 Mbps connection, the cable must be connected to a
100BASE-TX hub.
¾
Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.
¾ Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the
adapter’s connector.
Step 10
Attach the power supply to the KVM unit and plug the other end into an electrical receptacle.
14