LevelOne ViewCon KVM-0850 - Manual (Page 35)

KVM-0850/1650 IP KVM switch
(depending on the quality of the video input signal). All in all the default setting
should be suitable for most situations.
Video Settings through the remote console
Figure 5-11. Video Settings Panel
Brightness
Controls the brightness of the picture
Contrast
Controls the contrast of the picture
Clock
Defines the horizontal frequency for a video line and depends on the video
mode. Different video card types may require different values here. The default
settings in conjuction with the auto adjustment procedure should be adequate
for all common configurations. If the picture quality is still bad after auto
adjustment you may try to change this setting together with the sampling phase
to achieve a better quality.
Phase
Defines the phase for video sampling, used to control the display quality
together with the setting for sampling clock.
Horizontal Position
Use the left and right buttons to move the picture in horizontal direction while
this option is selected.
Vertical Position
Use the left and right buttons to move the picture in vertical direction while this
option is selected.
Reset this Mode
Reset clock, phase, and Horizontal/Vertical offset settings to the factory-made
defaults.
35