LevelOne ViewCon KVM-0850 - Manual (Page 23)

KVM-0850/1650 IP KVM switch
PC ports of KVM Switch do not be reset by reset command.
Keyboard Hot Key Commands:
You can also conveniently command KVM switch by switching ports through simple key
sequences. To send commands to KVM switch, the “SCROLL LOCK” key must be pressed
twice within 2 seconds. You will hear a beep for confirmation and the keyboard is in hot key
mode. If you have not pressed any key in hot key mode within 2 seconds (It means to key in any
key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back to under Operation System
(O.S.) control state.
Below are the different hot key commands (for local KVM):
within 2 seconds
+ + = Previous Channel
Scroll
Lock Scroll
Lock
↑
+ + = Next Channel
(Note: You also could press “up arrow key” or “down
arrow key” longer time to speed up selecting
the destination port)
Scroll
Lock Scroll
Lock
↓
+ + = Previous Bank
Scroll
Lock Scroll
Lock Page
Up
+ + + = Next Bank
Scroll
Lock Scroll
Lock Page
Down
To select PC port:
+ + + = Selected Bank and PC
Port No.
01~08 (8 port)
01~16 (16 port)
Scroll
Lock Scroll
Lock Bank
No 1~8
+ + = Beeper on local KVM Switch
(Note: The default Beeper function is ON and beeper
control is only for available for Scan Mode )
Scroll
Lock Scroll
Lock
B
+ +
+ = Auto Scan Scroll
Lock Scroll
Lock S
To get out of Auto Scan Mode, Press any key or SPACE bar.
+ + = OSD setting back to factory default value
(Note: Not including password)
Scroll
Lock Scroll
Lock
R
23