LevelOne ViewCon KVM-0850 - Manual (Page 76)

KVM-0850/1650 IP KVM switch
Warning
This process is not reversible and might take some minutes. Make sure the
KVM-0850/1650 's power supply will not be interrupted during the update process,
because this may cause an unusable card.
•
Thirdly, after the firmware has been stored, the panel will request you to reset the
KVM-0850/1650 manually. Half a minute after the reset, the KVM-0850/1650 will run with
the new firmware version and should be accessible. However, you are requested to login
once again.
Warning
The three-stage firmware update process and complete consistency check are
making a mistake in updating the firmware almost impossible. However, only
experienced staff members or administrators should perform a firmware update.
Make sure the KVM-0850/1650 's power supply will not be interrupted!
6.6.4 Unit Reset
Figure 6-34. Unit Reset
This section allows you to reset specific parts of the device. This involves the both keyboard
and mouse, the video engine and the IP-KVM itself. Resetting the card itself is mainly needed
to activate a newly updated firmware. It will close all current connections to the administration
console and to the Remote Console.
The whole process will take about half a minute. Resetting sub devices (e.g. video engine)
will take some seconds only and does not result in closing connections. To reset a certain
76