Land Pride ZT60 - Manual (Page 2)

2 Manual No. 357-178M 7/18/08
Land Pride
Assembly Instructions
■
Light Switch & Headlight
Refer to Figure 1:
Installation of headlights is easier if installed to light
brackets upside down as shown in Figure 1. The right
and left hand light brackets are identified by the rectangle
cut-out in the mounting leg. Right hand light bracket
shown in Figure 1 has a rectangle cut-out and the left
hand light bracket does not.
1. Remove machine screws (#11), lock washers (#4)
and u-bracket (#10) from headlight (#9).
2. Attach u-bracket (#10) to right hand light bracket (#1)
with two #10-24 x 1/2" black Phillips head machine
screws (#2), four #10 flat washers (#5), two #10 lock
washers (#6) and two #10-24 hex huts (#3).
3. Center u-bracket in light bracket frame and tighten
nuts (#3).
4. Position headlight with vent side facing away from
the u-bracket and pig tail pointing away from light
bracket mounting leg.
5. Attach headlight to u-bracket with Phillips/hex head
machine screws (#11) and lock washers (#4).
Tighten screws.
6. Insert headlight switch (#7) into the rectangle hole
with terminals down when oriented as shown in
Figure 1.
7. Install switch actuator (#8) with curved end of
actuator down when oriented as shown in Figure 1.
8. Repeat steps 1 to 5 for left hand light Installation.
(Right Hand Light Bracket (#1) Shown Upside Down)
Right Headlight Installation
Figure 1
24942
Wiring Harness Routing
Refer to Figure 2:
1.
Locate and identify the three plastic loom ends.
a. End “A” has one connector for attaching to the
right headlight and two female terminals for
attaching to the headlight switch.
b. End “B” has one connector for attaching to the left
headlight.
c. End “C” has two female/male terminals for
attaching to the hour meter and two male
terminals for connecting to the existing hour
meter wiring.
Wiring Harness
Figure 2
24943