Land Pride ZT60 - Manual (Page 5)

5 7/18/08 Manual No. 357-178M
Assembly Instructions
Land Pride
■
6. Attach back end of adapter plate to mower frame with
3/8" x 3/4" GR2 hex flange serrated screw (#6).
7. Tighten screws (#5 & #6) to 15-20 ft-lbs. torque.
Attach Adapter Plate (Right Side Shown)
Figure 10
Refer to Figure 11:
8.
Slip right hand light bracket (#1) behind nuts (#4) and
push down until end of slot is reached.
9. Tighten nuts (#4) to 20 ft-lbs of torque.
Attach Right Light Bracket to Adapter Plate
Figure 11
Refer to Figure 12:
10. Repeat steps 1 to 9 to mount the left light bracket.
Attach Adapter Plate and Left Light Bracket
Figure 12
IMPORTANT: Do not over tighten screws (#5 & #6).
Damage to fuel tank can occur if overtightened.
4 3 2
Bolts Shown in Back Square Holes for Mountin
Light Kit to Razor Z Models. Use Front Square
Holes When Mounting to ZXT & ZT Models.
5
25954
6
4
25956
1
25954
2
5 6
1
4
Method #3 - Light Bracket Mounted To ROPS
Refer to Figure 13:
1.
Attach right hand light bracket (#1) to ROPS as
shown with worm drive clamp (#8). Insert free end of
clamp through the loom hole in headlight and around
the ROPS post.
2. Make sure loom is not caught under the clamp.
Tighten clamp to draw light bracket up tight against
the ROPS post.
3. Run headlight and hour meter looms down the back
side of the ROPS. Loosely secure looms along the
ROPS post with plastic ties. Do not draw plastic
ties up tight.
4. Route hour meter loom behind the hydraulic hose
located under the expansion tank.
5. Repeat steps 1 to 4 above to mount the left headlight.
The left light does not include hour meter loom.
Attach Right Light Bracket to ZXT ROPS
Figure 13
NOTE: The left headlight may require additional
wire spliced into the wiring harness to mount the
light. Additional wiring and accessories to make the
splice are furnished by the customer.
Headlight
Loom
1 8
Plastic Ties
Hour Meter
Loom
25958
Expansion
Tank