Land Pride AT2672 User Manual
Page 14
12
Section 2: Operating Instructions
AT2672 Grooming Mowers 310-302M
Land Pride
07/02/07
1.
Clear the area to be mowed of rocks, branches and
other foreign objects that might be picked up and
thrown by the mower blades.
2.
Lower mower to ground. Set tractor throttle at idle.
Engage PTO to start blades rotating.
3.
Operate with 540 rpm PTO tractor. mower blades will
cut better at a 540 RPM than at reduced throttle.
4.
At first, begin mowing in a low gear and shift up until
the desired speed is achieved - maintain 540 PTO
rpm regardless of gear selection.
5.
After mowing the first 50 feet, stop and check to see
that the mower is adjusted properly.
6.
Do not make sharp turns or attempt to back up while
mower is on the ground.
7.
Do not engage PTO with mower in the fully raised
position. Do not engage or disengage PTO at full
throttle.
8.
Grass is best cut when it is dry. Mowing wet grass
can cause plugging resulting in grass clumps behind
the mower.
9.
Grass should be mowed frequently as shorter
clippings deteriorate faster.
10. If mowing extremely tall grass, it is best to raise
cutting height and mow the area, then lower cutting
height and mow a second time at the desired height.
11. Periodically check for foreign objects wrapped
around the Grooming Mower blades. Remove
foreign objects only after following “Tractor Shut
Down Procedure” on page 11.
Un-hooking the Mower
The following steps should be done when un-hooking the
Grooming Mower from the tractor.
1.
Park on a level solid surface.
2.
Shut tractor engine off and engage parking brake.
3.
Lower deck to level ground or onto blocks supporting
the deck just above ground level.
4.
Follow all tractor shut down procedures outlined on
page 11 before dismounting from the tractor.
5.
Unhitch Grooming Mower from tractor.
6.
See “Storage” on page 16 if mower is not going to
be used for a long time.
General Operating Instructions
By now you should have thoroughly read your Grooming
Mower Operator’s Manual, properly attached your Land
Pride Side Discharge Air Tunnel grooming mower to your
IMPORTANT: Stop PTO rotation immediately if
vibration occurs during operation. Wait for mower to
come to a complete stop. Follow all tractor shut
down procedures before dismounting from the
tractor to check for probable causes.
tractor, and reviewed the operating checklist. You should
have also inspected the area where you intend to mow
and cleared it of safety hazards and foreign objects. If
you have not yet completed all of these functions, it is an
absolute must that you do so now before proceeding.
Now that you are properly briefed and prepared its time
to start the tractor and move to your starting point. When
transporting to your mowing site, select a safe ground
transport speed. When traveling on roadways, transport
in such a manner that faster moving vehicles can easily
see you and pass you safely. Use “slow moving vehicle
signs” where appropriate. When traveling over rough and
hilly terrain, reduce your speed, avoid quick or sharp
steering corrections. Take extra care to insure that the
mower doesn’t come into contact with obstacles such as
trees, buildings or fences.
When you have arrived at the mowing site, start the
tractor raise the deck to make sure that everything is
properly attached and that the driveline is not in a bind or
in contact with the mounting frame. Also make sure the
tractor tires aren’t in contact with the deck. With the deck
still in the raised position, proceed to your starting point
and lower your deck to the ground in mowing position.
Reduce your tractor engine rpm to idle and engage the
PTO. Gradually raise the tractor engine rpm to achieve
the 540-rpm PTO speed. Now begin mowing at a ground
speed of approximately 4-5mph.
The proper mowing speed will ultimately be determined
by ground conditions, desired finish, common sense, and
good safe mowing practices by the operator. Grass is
best cut when it is dry. Mowing in wet grass can cause
clumping as grass is discharged out the side chute of the
mower. Grass should be mowed frequently if possible as
shorter clippings deteriorate faster. When mowing in tall
grass it is best to raise the cutting height, mow the area,
then lower the cutting height, and mow a second time if
you want a better finish.
After mowing approximately 50 ft., stop the tractor,
disengage the PTO, set the brake, turn off the engine,
remove the key, and dismount the tractor to see if the
mower is adjusted properly. If you need to dismount the
tractor on a hill or incline to inspect, adjust, or park the
mower for any reason, place wheel chocks under the
rear tires for added safety. Once you have made
necessary adjustments, you may continue mowing. Do
not engage the PTO at high engine rpm and avoid
making sharp turns if at all possible. If some one
approaches while you are mowing, disengage the PTO
and stop the tractor.
With a little practice and experience you will become very
good at operating your Land Pride Side Discharge Air
Tunnel Grooming mower. Look back often and always
keep people, animals, and valued possessions away
from the discharge chute Always remember that there is
no substitute for proper maintenance and good safe
operating practices. See “Features and Benefits” section
or “Product Specifications” for additional information and
performance enhancing options.