Land Pride AT2672 User Manual
Page 18
16
Section 4: Maintenance & Lubrication
AT2672 Grooming Mowers 310-302M
Land Pride
07/02/07
V-Belt Installation
Refer to Figure 4-4:
This illustration is also on the label located on the top of
the mower deck.
1.
Remove the right hand and the left hand belt covers.
2.
Disengage belt tension by loosening the eyebolt (#1)
and removing the spring (#2) from the tension-chain
link (#3).
3.
With tension relieved from belt remove old belt from
pulleys.
4.
To install a new belt be sure the belt is positioned in
all the pulley grooves. Engage belt tension by
assembling the tension spring back on the eyebolt
and tightening the eyebolt to apply tension to new
belt. Check the belt tension, refer to Figure 3-2 on
page 13.
5.
Reinstall all belt covers and secure in place with
hardware.
V-Belt Installation
Figure 4-4
18755
Storage
At the end of the working season or when the mower will
not be used for a long period, it is good practice to clean
off any dirt or grease that may have accumulated on the
mower and any of the moving parts.
1.
Clean as necessary.
2.
Check the blades for wear and replace if necessary,
see Servicing Mowing Blades, this section on page
14.
3.
Inspect the mower for loose, damaged or worn parts
and adjust or replace as needed.
4.
Lubricate as noted in the Lubrication portion of this
section starting on page 17.
5.
Store unit inside if possible for longer life.
Repaint parts where paint is worn or scratched to prevent
rust. Ask your dealer for Aerosol Land Pride Beige touch-
up paint #821-011C.