La Crosse Technology WS-7016U - Manual (Page 5)

17
The Remote Control Sender can be mounted in
two ways:
 with the use of screws or,
 using the adhesive tape.
1. MOUNTING WITH THE
SCREWS
a) Remove the mounting bracket
from the Remote Control
Sender (figure 2).
b) Place mounting bracket over
desired location. Through the
three screw holes of the
bracket, mark the mounting
surface with a pencil.
c) Where marked, drill holes
into mounting surface using
an appropriate size drill bit.
d) Screw mounting bracket onto
the mounting surface. Ensure
that the screws are flush with
the bracket.
18
2. MOUNTING WITH
ADHESIVE TAPE
a) With a nonabrasive solution,
clean and dry the back of the
mounting bracket and the
mounting surface to ensure a
secure hold. The mounting
surface should be smooth and
flat.
b) Remove the protective strip
from one side of the tape.
Adhere the tape to the
designated area on the back of
the mounting bracket.
c) Remove the protective strip
from the other side of the
tape. Position the Remote
Control Sender in the desired
location, ensuring that the
Indoor Temperature Station
can receive the signal.
19
B. THE INDOOR TEMPERATURE
STATION
Note: Before mounting the Indoor
Temperature Station make sure that it is
able to receive signals from the Remote
Control Sender.
The Indoor Temperature Station can also
be mounted in two ways:
 with the table stand or,
 on the wall with the use of a wall
hanging screw (not included).
1. USING THE TABLE-STAND
a) The Indoor Temperature
Station comes with the table
stand already mounted. If you
wish to use the table-stand all
that is required is to place the
Indoor Temperature Station in
an appropriate location.
20
2. WALL MOUNTING
a) Remove the table stand. To
do this, pull down on the
stand from the rear and rotate
forward.
b) Fix a screw (not included)
into the desired wall, leaving
approximately 3/16 of an inch
(5mm) extended from the
wall.
c) Place the Indoor Temperature
Station onto the screw using