La Crosse Technology WS-7016U - Manual (Page 7)

25
Remote Control Senders and view
their minimum and maximum
temperatures.
3. To reset the OUTDOOR
MINIMUM AND MAXIMUM
TEMPERATURES, follow step 1
above and the directions in
sections V.A. through V.B. This
will reset the minimum and
maximum for only the selected
Remote Control Sender.
TROUBLESHOOTING
Problem
Solution
“--. -” appears in
the OUTDOOR
LCD of the Indoor
Temperature
Station. Batteries may be inserted wrong in
Remote Control Sender—correct the
polarity
The batteries may be weak—replace
with new batteries.
26
The Remote Control Sender may be
out of its 80 foot (25m) range—bring
the units closer together.
“--.-” appears in
the OUTDOOR
LCD of the Indoor
Temperature
Station.
(continued) Obstacles such as walls, concrete,
metal window frames, or large metal
objects, may be obstructing signal
transmission from the Remote Control
Sender—Relocate the Remote Control
Sender, within range, where there are
no obstructions.
Other equipment in vicinity operating
on 433MHz may interfere with
signal—turn off other equipment or
relocate Indoor Temperature Station,
wait a few minutes for signal to be
found.
Temperature exceeds range of the
Remote Control Sender—see
specifications for range.
27
No temperature in
the LCD of the
Remote Control
Sender. The batteries may be inserted wrong
or weak—check the polarity of
batteries or replace with new batteries.
Remote Control Sender out of its 80
foot (25m) range—bring the units
closer together.
If problem persists contact La Crosse
Technology for replacement.
The LCD of the
Indoor
Temperature
Station is blank. Check for proper battery installation.
The batteries may be weak—replace
with new batteries.
The LCD of the
Indoor
Temperature Contact La Crosse Technology for
replacement.
28
Station is blank.
(continued)
Temperature is
“incorrect”
Temperatures can vary depending on
the location of the Remote Control
Sender. The thermometers are not
100% accurate (the WS-7016U is
accurate to +/- 2
F). If you are sure
the temperature is wrong (the unit
reads 110
F, when it is actually 70
F) reset entire system by removing
all batteries and following set-up
instructions. If this does not solve the
problem, contact La Crosse
Technology for replacement.
Problem not
covered under the
warranty (ie.
Dropped unit into
water). Call La Crosse Technology to order
replacement part. We will accept Visa,
MasterCard, Discover, or prepayments
by check.