La Crosse Technology WS-7016U User Manual
Page 6
21
the hanging hole on the
backside. Gently pull the
Station down to lock the
screw into place.
VIII.
USING MULTIPLE REMOTE
CONTROL SENDERS
Your WS-7016U Indoor Temperature Station
can receive signals from five different Remote
Control Senders (The TX3U features
temperature data transmission and the TX3UP
offers the same plus a 10’ probe to insert in a
pool, spa, soil, etc.). Assign a number to each
Remote Control Sender (i.e. #1 will be for
outdoors, #2 will be for the basement, etc.).
This will help you determine which
temperature, from which Sender, you are
reading on the Indoor Temperature Station.
Note: When setting up multiple units it is
important to insert batteries first into all the
Remote Control Senders, and in numeric
sequence. Second install batteries into the
22
Indoor Temperature Station. Transmission
problems will arise if this is not done correctly
and if the total time for set-up exceeds 6
minutes.
A. UP OF MULTIPLE UNITS
1. It is necessary to remove the
batteries from all existing units in
operation.
2. Remove the battery covers to all
Remote Control Senders. See
section I.A.2.
3. Place all Remote Control Senders
in sequential order.
#1 #2
#3
23
1
4. In sequential order, install
batteries. (Refer to instructions in
I.A.3 through I.A.5).
5. Install batteries into the Indoor
Temperature Station. (Refer to
instructions in I.B.).
6. Follow directions in section II.A
to set the time, section III.A to
select Fahrenheit or Celsius, and
section VII. A to mount.
B. VIEWING MULTIPLE REMOTE
CONTROL SENDERS ON THE
INDOOR TEMPERATURE
STATION
1. To view the temperature of a
different Remote Control Sender,
press the RESET button.
2. In the OUTDOOR LCD a
should shift and become a
This indicates that you are
2
24
now reading the temperature of
the Remote Control Sender you
designated as #2.
3. Repeat step 1 to view the 3
rd
, 4
th
,
and 5
th
(depending on how many
are set up) temperatures sent by
the Remote Control Senders.
Continue to press RESET until you
return to the first Remote Control
Sender.
C. VIEWING THE FEATURES OF
MULTIPLE REMOTE CONTROL
SENDERS
1. Press the RESET button to select
the Remote Control Sender you
wish to view.
2. To view the OUTDOOR
MINIMUM AND MAXIMUM
TEMPERATURES, follow
directions in section IV.B. While,
in this mode press the RESET
button to toggle through different