LCD Digital DGP2-641 - Manual (Page 14)

14 System Manager’s Manual
7.0 TROUBLE DISPLAY
If your system experiences any problems, “Trouble(s) [TRBL] to View” will appear on the LCD screen. The
Trouble Display will only display the troubles that occur in the area(s) to which the keypad has been assigned.
Potential troubles have been sorted into eight groups. Only the troubles which are relevant to you are listed and
described below. If a trouble that is not described or listed below appears, contact your Installer.
To View the Trouble Display:
1. Press the [ TRBL ] button when “Trouble(s) [TRBL] to View” appears on the LCD screen. The Group Head-
ing with the trouble will appear on the screen.
2. Press the [ S] and [T] buttons to scroll between the Groups experiencing a trouble.
3. Press the [ NUMBER ] of the Trouble you wish to view.
We strongly suggest that if any troubles occur, contact your Installer immediately to have
your system serviced.
7.0.1 G ROUP 1: S YSTEM
AC Failure
The control panel has detected a power failure. This means that your system is running on the
backup battery. If this trouble occurs when your establishment is not experiencing a power failure, call
your Installer for repairs.
Battery Trouble
The backup battery is disconnected, needs to be recharged, or replaced.
Bell Absent
The system has detected that the bell or siren is not connected.
7.0.2 G ROUP 5: Z ONE T AMPER
The zone(s) that was tampered with will be displayed on the LCD screen.
7.0.3 G ROUP 6: Z ONE L OW B ATTERY
If a wireless device's battery needs to be replaced, the zone that is assigned to the device will be
displayed on the LCD screen.
7.0.4 G ROUP 7: Z ONE F AULT
A wireless device is no longer communicating with its receiver, or a connection or CleanMe
TM
trouble
is occurring with your smoke detectors.
7.0.5 G ROUP 8: C LOCK L OSS
The time and date have been reset to the default. This is the only trouble that we recommend that you
correct. “Clock Loss [8] to Set” will appear on the LCD screen after you press the [
TRBL ] button. Refer
to section 8.3 on page 15 to set the time and date.
7.1 EVENT RECORD DISPLAY
The Event Record Display will record the user-initiated actions that occurred in your system as well as any
alarms or troubles (i.e. “Access Granted”). You will only be able to view the events that occurred in the area(s)
assigned to your User Access Code.
To view the Event Record:
1. Enter your [ ACCESS CODE ].
2. Press the [7] button.
3. If you have access to more than one area, select the area(s) you wish to view (refer to section 2.3 on page 5).
4. Use the [
S] and [T] buttons to scroll between the events.
5. Press the [ CLEAR ] button to exit.
Once you have entered Event Record Display mode, you can change the order that the Event Record screens
appear by pressing the [7] button. If you already know the number of the event you want to view, press the
[
MEM ] button after step 3 above, and then enter the event's number.