LCD Digital DGP2-641 - Manual (Page 19)

LCD Keypad 19
Voice-Assisted Arm/Disarm Module
Operating Instructions
11.0 INTRODUCTION
Congratulations on choosing the Paradox InTouch Voice-Assisted Arm/Disarm Module (APR3-ADM2). InTouch
turns any touch-tone telephone into a keypad. With InTouch, you can now arm or disarm your Digiplex security
system as well as activate or deactivate your InTouch’s output all from your telephone. Using detailed voice prompts
to guide your way, the InTouch is as simple as picking up your telephone.
12.0 ACCESS CODES
InTouch uses your Digiplex User Access Code to grant you access to your Digiplex Security System. The User
Access Code entered on your Digiplex system keypad is the same you would use to enter on your telephone.
13.0 HOW DO I USE IT?
STEP 1: Pick up your telephone and dial the telephone number of the line that your InTouch is connected to. The
InTouch will now ask you to enter your Digiplex User Access Code.
STEP 2: Enter your Digiplex User Access Code.
If your Digiplex Security System is programmed to accept variable code lengths, you must
press the [#] key after entering your User Access Code.
STEP 3: Keys [1] to [4] on your telephone represent areas 1 to 4. To arm or disarm your Digiplex Security System,
press the desired area’s number on your telephone. This will toggle the area’s arming state from armed to
disarmed and vice versa (refer to section 16.0 on page 20).
STEP 4: To activate or deactivate the InTouch’s output, press the [#] key and then the [0] key (refer to section 16.0
on page 20).
14.0 THINGS YOU SHOULD KNOW
14.1 WHEN ACCESSING YOUR INTOUCH...
• If you are using an answering machine or service, call the InTouch, hang up after one ring, wait between 10 and 255
seconds (depending on how Intouch was programmed by your Installer), and then call the InTouch again to access it.
14.2 WHEN ARMING OR DISARMING...
• You will only be able to arm or disarm areas that your User Code has access to.
• If you were to arm an area with an open zone, Digiplex will Force arm the area. This will only happen with User Access
Codes that have the Force arming feature enabled.
14.3 WHEN ACTIVATING OR DEACTIVATING A PGM...
• Your InTouch’s output can be used to turn on lights, open or close a garage door and much more. Ask your installer
about this useful feature.
• If the InTouch’s output is not operational, you will not be able to activate or deactivate the output.