Lexmark 4227-X00 - Manual (Page 101)

4-38 Service Manual
4227-X00
Reassembly:
1. Remove the paper separator while first installing the side frame
loosely. Be sure the lower pinch roller spring is above the
bushing.
2. Remove the screw from the right end of the paper separator.
3. Install the left end of the paper separator first, then bend the
right side frame slightly to get the right end installed.
4. Reinstall the separator screw through the hole above the slider
cam.
5. Set the printhead to platen gap.
Sub Logic Board Removal
1. Remove the top cover.
See “Top Cover Removal” on page 4-6 .
2. Disconnect the power connector and the signal connector from
the sub logic board.
3. Remove the three screws.
4. Disconnect the printhead cables and remove the sub logic
board.
Reinstallation:
For ease of reassembly, remove the flexible signal cable from the
main logic board and connect it to the sub logic board before
reinstalling the sub logic board. Remember to reconnect the ground
lead to the bottom mounting screw.