Lexmark 4227-X00 - Manual (Page 97)

4-34 Service Manual
4227-X00
Printhead Cables Removal
1. Remove the top cover.
See “Top Cover Removal” on page 4-6 .
2. Remove the two screws on the cable retainer and disconnect
the two cables. These are ZIF connectors.
3. Disconnect the other end of the cables from the sub logic board
and pull the cables from under the ribbon motor.
4. The cables are attached to the carrier plate with double-faced
tape.
Reinstallation:
Be sure the tension pulley plate does not interfere with the printhead
cables.