Lexmark 4227-X00 - Manual (Page 53)

2-30 Service Manual
4227-X00
Ribbon Drive Service Check
In normal operation, the ribbon knob rotates counterclockwise
whenever the carrier moves to the left.
FRU/Symptom Action
1 Ribbon Drive
Gear Train Remove and inspect the ribbon. Make sure the
knob turns with even, moderate force and the
ribbon feeds correctly.
Inspect the gear train from the ribbon motor to
the ribbon drive post.
Check the “Printhead-to-Platen Gap
Adjustment” on page 4-2 .
2 Ribbon Motor If printing seems normal, but the ribbon is not
moving, remove the ribbon and turn power on.
The ribbon drive post should turn several times
during POST. Disconnect the ribbon motor
connector CN19 from the main logic board.
The winding resistance should be
118 ohms ±
5 between pins:
1 and 5, 3 and 5, 2 and 6, 4 and 6.
Pin 5 should show an open circuit to pins 2, 4
and 6. Pin 6 should show an open circuit to
pins 1, 3, and 5.