Copying line/trunk button assignments, Copying – Lucent Technologies MERLIN LEGEND 5 User Manual
Page 250
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-32
Centralized Telephone Programming
6
Console/Display Instructions
Additional Information
PC
Either continue to copy line assignments and programmed features from the
copy extension shown to another extension or go to Step
.
Return to the Centralized Programming menu.
Select
Exit
.
!
Save your entry.
Select
Enter
.
Return to the Centralized Programming menu.
Select
Exit
.
!
Copying Line/Trunk Button Assignments
6
Use this procedure to copy outside line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and Night Service information (for operator
positions only). You can copy from one extension to another or to a block of
extensions with identical requirements. Use system programming for this
procedure.
If you are copying assignments from an operator position to a block of extensions
that includes both operator and non-operator extensions, the information is copied
only to the operator positions; the non-operator positions are not affected.
Similarly, if you are copying assignments from a non-operator position to a block
of extensions that includes both operator and non-operator extensions, the
information is copied only to the non-operator positions; the operator positions are
not affected. The system does not provide an error tone to signal that the copy did
not work for all of the extensions in the block.
If you are performing this procedure for the first time, see the detailed steps in
“Copy Line/Trunk Assignments” of the “Telephones” section, Chapter 3,
System
Programming.
Select
Enter
(
) to continue copying
line assignments from the extension
currently displayed on Line 1 to additional
extensions.
Select
Next
(
%
) if the extension
numbers to be copied to are sequential.
Select
Enter
(
) after completing
programming.
Return to Step
programming. The extension to be copied
from is displayed on Line 1.