Linksys EPSX3 - Manual (Page 6)

EtherFast 10/100 PrintServers
Chapter 3: Getting to Know the
EtherFast ® 1-Port PrintServer
Power Green. The Power LED illuminates when the PrintServer is
powered on.
Act Green. If the Act LED is continuously illuminated, the
PrintServer is actively sending or receiving data.
LAN Green. The LAN LED illuminates to indicate that the
PrintServer is successfully connected to a device through the
LAN port.
Error Red. The Error LED lights up when there is a problem print-
ing to the indicated printer.
5
Instant EtherFast ® Series
Power Port This port on the back of your unit connects your
Switch’s power adapter.
Printer 1, Printer 2, These three parallel (LPT) ports connect to your
Printer 3 printers.
LAN Port This Ethernet RJ-45 port connects to your network
device, such as a PC, other print server, remote hard
drive, and any other networkable device. Use UTP
Category 5 or better cabling with this port.
Reset Button Briefly pressing the Reset Button will refresh the
PrintServer’s connections, potentially clearing any
jammed links. Holding in the Reset button will gen-
erate a diagnostic print-out.
4
The 3-Port PrintServer’s Ports
The 1-Port PrintServer’s LEDs
Figure 2-2
Figure 3-1
Reset Button
This button has two functions: to restore the factory default settings and
to print a diagnostic test page containing all current settings.
To reset the factory default settings:
1. Turn the PrintServer OFF.
2. Press and hold the Reset button. While pressing the button, switch the Print
Server ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will
be printed, showing the new (default) settings.
To generate a diagnostic test printout:
1. Ensure that the PrintServer and the attached Printer are ON.
2. Press the Reset button and hold it in for 2 seconds.
3. The diagnostic test page, containing the current settings, will be printed,
unless you have a PostScript printer. PostScript printers are unable to print
this page.