Lantronix UDS100 - Manual (Page 8)

8
1 1 : : U U s s i i n n g g T T h h i i s s G G u u i i d d e e
Purpose and Audience
This guide provides the information needed to configure, use, and update the UDS
device server. It is for system administrators and those responsible for installing and
maintaining the UDS.
Chapter Summary
The remaining chapters in this guide include:
2: Introduction Describes the main features of the UDS and the protocols it
supports.
3: Getting Started Provides information for installing your unit and getting it up
and running.
4: Configuring the UDS
Using Web Manager Provides instructions for accessing Web Manager and using
it to configure settings for the UDS.
5: Configuring the UDS
Using Telnet or the Serial
Port Provides instructions for accessing Setup Mode (command
line interface) using a Telnet connection through the
network or a terminal or terminal emulation program through
the serial port. Details the settings that you must configure.
6: Updating Firmware Provides instructions for obtaining the latest firmware and
updating the UDS.
7: Using Monitor Mode Provides instructions for accessing and using the command
line interface to monitor the network and diagnose
problems.
8: Troubleshooting and
Contact Information Describes common problems and error messages and how
to contact Lantronix Technical Support.
9: Connections and Pinouts Provides descriptions and illustrations of connection
hardware.
10: Technical Specifications Lists technical specifications for the UDS10 and the
UDS100.
A: Alternative Ways to
Assign an IP Address Provides detailed information about using DHCP, AutoIP,
BOOTP ARP, and Telnet to assign an IP address.
B: Binary to Hexadecimal
Conversions Provides instructions on converting binary values to
hexadecimals and tables listing all UDS configuration
options in hexadecimal notation.