Luce PT-L6510E - Manual (Page 25)

25
ENGLISH
Using the Shutter function
Using the Freeze function
The picture freezes each time you press the remote control “FREEZE” button.
The shutter function can be used to momentarily turn off the picture and sound from the projector when the projector
is not being used for short periods of time, such as during breaks in meetings or when carring out preparation. The
projector uses less power in shutter mode than it does in normal projection mode.
1. Press the remote control/ “SHUTTER” button to mute both picture and sound.
Both video and audio are turned off.
2. To clear muting, press any button on the remote control or projector.
Apear the picture and sound.
Still image Motion image
(FREEZE)
Left-side exhaust guide
Fixing pin (2 sets)
Right-side exhaust guide
Advice on the installation of exhaust guides
Hot air from the cooling fan vents may in rare cases cause disturbances to the screen image.
If this should occur, install the attached exhaust guides.
1. Identify the left-side and right-side
exhaust guides, then insert the tabs of
the relevant guide into the holes on the
front of the projector.
2. Insert the fixing pins from the bottom
of the projector and tighten them
securely.