Luce PT-L6510E - Manual (Page 39)

39
ENGLISH
Using the remote terminal
Using the remote terminal built into this projector, it is possible to operate the projector from an external location
from where infrared remote control signals cannot be received, by using a remote control panel.
Pin assignment and control
Short pin 1 and pin 9 when controlling.
Example of a control panel layout
Projector set up in a meeting room
;;;
Control panel located in a different room
STANDBY ON
VIDEO/
S-VIDEO
S-VIDEO
RGB2
RGB
VIDEO
RGB1
LAMP
OFF ON
Remote terminal ON / OFF
RGB/VIDEO
INPUT SELECT
DVI
VIDEO
RGB
DVI switch
Pin No. Name
Remoto terminal ON / OFF
Lamp
RGB/VIDEO
Switch input modes
Switch DVI modes
On
On
VIDEO
S-VIDEO
RGB2
DVI
Off
Off (standby)
RGB
VIDEO
RGB1
VIDEO
RGB
Description
(When is VIDEO)
(When is RGB)
(When is RGB)
(When is VIDEO)
(When is RGB)
(When is VIDEO)
(When is RGB)
Short with pin Open
Note
• The “POWER”, “RGB” and “VIDEO” buttons on the remote control and projector will not operate when pins
1 and 9 are shorted. RS-232C commands will also be ignored.
• Do not short pins. 1, 2, 3, 5 or 6 when pin 9 is open. If this is done, the projector will ignore signals from the
remote control.
D-Sub 9-pin (female)
external appearance