Luce PT-L6510E - Manual (Page 44)

44
8. Insert the power cord plug into the wall outlet and then press the MAIN POWER switch.
Caution
• If the power does not turn on even after turning the MAIN POWER switch “I”, turn the MAIN POWER “O”,
confirm that the lamp unit and door are installed correctly, and turn on again.
9. Press the “POWER” button so that a picture is projected onto the screen.
11. Press the “ENTER” button to display the
“OPTION2” screen, and then use the
a n d
b u t t o n s t o s e l e c t “ L A M P
RUNTIME”.
12. Press and hold the “ENTER” button on
the projector or the remote control for
approximately 3 seconds.
10. Press the “MENU” button to display the
MAIN MENU screen, and then press the
and buttons to move the cursor to
select “OPTION2”.
Note
• If the “MENU” button is pressed, the lamp time
resetting screen will be cancelled.
13. Press the and buttons to select for replacement lamp setting.
L1 RESET: Replace the LAMP1
L2 RESET: Replace the LAMP2
L1+L2 RESET: Replace the LAMP1 & LAMP2
14. Press the POWER button to turn off the power.
This will reset the cumulative usage time for the lamp unit to zero.
MENU
INDEX WINDOW
PICTURE
AUDIO
OPTION 2
OPTION 1
ZOOM/FOCUS
POSITION
LANGUAGE
SELECT ENTER
OPTION 2
LAMP POWER
LAMP SELECT
FUNCTION 1
SET ID
L1 RESET
USER MODE
HIGH
MUTE
DUAL
ALL
SELECT ADJ ESC
[ POWER OFF ]
Replacing the lamp unit
OPTION 2
LAMP POWER
LAMP SELECT
FUNCTION 1
SET ID
LAMP RUNTIME
USER MODE
HIGH
MUTE
DUAL
1820 H 1
ALL
SELECT ADJ ESC
The “LAMP RUNTIME” will change to “L1 RESET
[POWER OFF]” or “L2 RESET [POWER OFF]”.